Make certain the flooring is structurally solid before you set down any sort of floor. It’s advised that you work with a one-fourth-inch cement board to get some floor types. From that point, you’ll wish to figure out the last design of your own boards. Remember to stagger the jointsand do not line the joints up with people from the subfloor.
Apply a coat of modified thin-set or mortar and firmly affix the tiles into it at the desired design. Fasten the boards down using the nails or screws recorded within the substances section and make certain never to over drive them. Fill out the spaces left with precisely the very same mortar you accustomed to set the tiles.
Tape a ground joints before tiling. Work with a high-strength, alkali-resistant glass tape that is at least two inches broad, and then put in it at the mortar layer. Be certain to check out all directions you are offered in official substances, which means you’re able to make sure the safety and strength of your own flooring. 99j4hoes6k.